| New and Interesting Products |
|
|
| 25 W Solid State Power Amplifier from 2.0 to 8.0 GHz | |
EMC Power Amplifiers
from Exodus Advanced Communications
|
| The AMP20189 from Exodus Advanced Communications is a Solid-state Power Amplifier that operates from 2.0 to 8.0 GHz. It delivers a saturated output power of 25 W and a power gain of more than 43 dB. This power amplifier is based on a Class A/AB Linear design to provide instantaneous bandwidth, high efficiency, and unprecedented reliability and ruggedness. It has a return loss of less than -10 dB and a 2-tone intermodulation (IMD) of -30 dBc. |
| Download Datasheet |
|
|
|
|
| 100 W EMC Power Amplifier from 2 to 6 GHz | |
EMC Power Amplifiers
from AMCOM Communications, Inc.
|
| The AM206050SY-7H from AMCOM Communications is an EMC Power Amplifier that operates from 2 to 6 GHz. It delivers a CW output power of 100 W (50 dBm) and a small signal gain of 50 dB. This power amplifier has a gain control range of 30 dB and a return loss of -12 dB (input) & -13 dB (output). It has a display for temperature, current, and power monitoring and can be controlled via an Ethernet interface. This amplifier requires an AC supply of 1110-240 V and consumes 600 W of power. |
| Download Datasheet |
|
|
|
|
| EMI Test Receivers from 2 Hz to 50 GHz | |
EMI Receiver
from Ceyear
|
| The 3916 Series from Ceyear Technologies are EMI Test Receivers that operate from 2 Hz to 50 GHz. These high-performance instruments support EMC standard compliance testing, fast FFT time-domain analysis, EMI diagnostics, and full-featured spectrum analysis. They have a built-in low-noise amplifier and a full-band preselector that achieves a displayed average noise level as low as -163 dBm (with the amplifier on). |
| Download Datasheet |
|
|
|
|
| Low Noise Broadband Amplifier from 100 MHz to 18 GHz | |
EMC Pre-Amplifier
from US Microwave Laboratories
|
| The USMC10180L from US Microlabs is a Low Noise Amplifier (LNA) that operates from 100 MHz to 18 GHz. It is designed for EMC testing and certification, and permits visualization of signals that would otherwise appear below the noise floor during radiated emissions testing. This amplifier provides 24 dB of gain with a noise figure of 3 dB and an output P1dB of more than +12 dBm. |
| Download Datasheet |
|
|
|
|
| EMC Scanning System from 150 kHz to 6 GHz for High-Speed PCB Testing | |
EMC Scanner
from Y.I.C. Technologies
|
| The EMScannerR+ from YIC Technologies is an EMC Scanning System that operates from 150 kHz to 6 GHz. It is designed to empower design engineers to diagnose and resolve EMC/EMI issues in ultra-high-speed PCBs and ICs with high resolution. This system consists of a built-in spectrum analyzer with 1218 H-field probes, delivering repeatable and reliable results in under a second, thereby reducing the testing time. |
| Download Datasheet |
|
|
|
|
| RF Shielded Test Enclosure from 20 MHz to 12 GHz | |
Shielded Test Enclosure
from LabiFix Innovations
|
| The LBX1060 from LabiFix Innovations is an RF Shielded Test Enclosure that covers frequencies from 20 MHz to 12 GHz. It has a shielding effectiveness of up to 95 dB and is designed and developed for testing wireless technology. This shielded enclosure has a high-performance RF absorber lining and EMI filters on data ports & power lines. It also has an RF gasket system and high-performance shielded air vents for adequate air flow. This enclosure has Ethernet - 10M, 100M, 1G & 10G, USB 2.0 & 3.0 - C type, RJ45, DB9, DB15, DB25, DB50 & RJ11 interfaces and SMA, N Type, BNC & TNC RF interfaces. |
| Download Datasheet |
|
|
|
| Sponsored by Exodus Advanced Communications | | | |
|
|
| Shielded OTA Reverberation Test Chamber from 5 to 170 GHz | |
Reverberation Chamber
from Antennex B.V
|
| The RC-01-0202 from ANTENNEX BV is a Shielded Over-The-Air (OTA) Reverberation Chamber that operates from 5 to 170 GHz. It is designed for accurate testing of power-related metrics (TRP, Efficiency, Gain, Noise Figure, and FMCW). This test chamber can measure a Device Under Test (DUT) with maximum dimensions of 300 x 300 x 300 mm and includes two mode-stirring mechanisms. |
| Download Datasheet |
|
|
|
|
| USB Real Time Spectrum Analyzer from 9 kHz to 6.2 GHz | |
Spectrum Analyzer
from Tektronix, Inc.
|
| The RSA306B from Tektronix is a Real Time Spectrum Analyzer that covers a frequency range of 9 kHz to 6.2 GHz. It has an acquisition bandwidth of 40 MHz and delivers a real-time IF acquisition data rate of 112 Ms/s (16-bit integer samples) with a sweep speed of up to 16.5 GHz/sec. This spectrum analyzer has a DANL of less than -163 dBm/Hz and a phase noise of less than -127 dBc/Hz. |
| Download Datasheet |
|
|
|
|
| GTEM Cell from 0.1 to 8 GHz | |
TEM / GTEM Cell
from 3Ctest
|
| The GTEM 250 from 3Ctest is a GTEM Cell that operates from 0.1 to 8 GHz. It provides shielding effectiveness greater than 50 dB (10 kHz to 10 MHz), a VSWR of 1.2:1, and supports input power levels up to 250/500 W. This GTEM cell can accommodate EUTs of up to 200 x 200 x 150 mm in size and has a testing volume of 150 x 150 x 100 mm with a septum height of 250 mm. It measures 1150 x 640 x 440 mm and has an N type connector. |
| Download Datasheet |
|
|
|
|
| EMC Turntable for Rotational Motion for DUTs | |
Antenna Positioners
from Noordin Etech
|
| The EMC Turntable Series from Noordin Etech is an EMC Turntable that provides high-precision rotational motion for DUTs in anechoic chambers or open-area test sites. It has a platform diameter of 1.2, 1.5, 2.0, 3.0, 4.0, 5.0 & 6.0 m and a load capacity of 300 kg to 15 Tons. This platform has an adjustable rotational speed of 0.4 to 2.0 rpm. It has a precision chain drive system (for small models) & a gear drive system (for heavy models), and an EMC shielded stepper motor or EMC hardened AC motor. |
| Download Datasheet |
|
|
|
|
| EFT/Burst Generator from 1 kHz to 1200 kHz | |
EFT / Burst Generator
from EMCSOSiN
|
| The EFT T6 from EMCSOSiN is an EFT/Burst Generator that operates from 1 kHz to 1200 kHz. It produces an output voltage of 0.2~±6 kV with positive, negative & alternating polarities. This generator can produce 1-255 continuously adjustable pulses with a pulse width of 35 to 150 ns and a synchronous, asynchronous, or automatic phase of 0-359°. It has a continuously adjustable running time of 1-9999 s and a continuously adjustable burst period of 150-9999 ms. |
| Download Datasheet |
|
|
|
|
| ESD Test Simulator with a Discharge Voltage of 16/30 kV | |
ESD Simulator
from Laplace Instruments
|
| The ONYX16 from Laplace Instruments is an Electrostatic Discharge (ESD) Test Simulator that generates a discharge voltage of 16/30 kV. It consists of modular RC units, a multilingual interface, remote control software, a built-in LED light, and temperature & humidity displays. This ESD simulator’s built-in interfaces allow for trouble-free use across all types of test sites. |
| Download Datasheet |
|
|
|
| Sponsored by Exodus Advanced Communications | | | |
|
|
| Magnetic Field Generator with Magnetic Field Strength of up to 1200 A/m | |
Magnetic Field Generator
from Everfine
|
| The EMS61000-8K from Everfine is a Magnetic Field Generator that produces a magnetic field strength of up to 1200 A/m. It has a current distortion rate of less than 0.8% and produces a Sinewave current waveform of adjustable frequency from 45 to 65 Hz and a current output of 1-400 A (1-99999 s), 401-500 A (1-999 s) & 501-1200 A (1-9 s). |
| Download Datasheet |
|
|
|
|
| EMC Measurement and Analysis Software for Automotive Components | |
EMC Test Software
from TOYO Corporation
|
| The ES10/VE from TOYO Corporation is an EMC Measurement and Analysis Software designed for vehicles and on-vehicle electrical/electronic components. It uses TOYO’s advanced tools to offer broad hardware compatibility and enhanced usability. The software supports key automotive EMC standards, including CISPR 25 Edition 4 for high-voltage EV/HV power systems, and facilitates precise EMI emission measurements by working with a variety of EMI receivers. |
| Download Datasheet |
|
|
|
|
| EMC Near-Field Probe Set with H20, H10, H5 & E5 Probes | |
Near Field Probe
from TEKBOX Digital Solutions
|
| The TBPS01 from Tekbox Digital Solutions is a Near-Field Probe that operates up to 6 GHz. It is designed to measure E-field and H-field strengths by conducting radiated emissions measurements. This near-field probe acts as a wideband antenna that picks up radiated RF emissions from components, PCB traces, housing openings or gaps, thereby enabling location and identification of potential sources of interference. |
| Download Datasheet |
|
|
|
|
| 850 nm Shielded Fiber Optic Converter for RS485 and RS422 Networks | |
Shielded Fiber Optic Converter
from PONTIS EMC
|
| The foRS485/422 from PONTIS EMC is a Shielded Fiber Optic Converter that enables the bidirectional connection of RS485 and RS422 networks using two multimode fiber optic cables. It operates at a wavelength of 850 nm and delivers a data transfer rate of up to 10 Mbit/s over a distance of over 500 m. This fiber optic converter is fully transparent to RS485 & RS422 data and is capable of driving large bus loads with extended network sizes up to 10 nF bus capacity. |
| Download Datasheet |
|
|
|
|
| EMC Antenna Kit from 30 MHz to 18 GHz | |
EMC Antenna Kit
from Narda Safety Test Solutions
|
| The AS-05 from Narda Safety Test Solutions is an EMC Antenna Kit that covers a frequency range of 30 MHz to 18 GHz. It includes a BC-01 Biconical Dipole, LP-04 Log Periodic Dipole Array and a DR-01 Double Ridged Horn Antenna designed for radiated emissions and immunity testing that can be used in conjunction with any receiver or spectrum analyzer. These antennas have a gain of -15 to +2 dBi (BC-01), 6 dBi (LP-04) and 9-16 dBi (DR-01). |
| Download Datasheet |
|
|
|
|
| Rod Antenna for E-Field Measurements from 9 kHz to 30 MHz | |
EMC Antenna
from EMC Electronic
|
| The RA10K30M from EMC Electronic is a Rod Antenna that operates from 9 kHz to 30 MHz. It is designed for low-frequency E-field generation and measurement in EMC test laboratories. This antenna consists of a 104 cm rod and an impedance-matching amplifier with optional ground plane, calibration adapter, and bonding kits. It has an antenna factor of 16 dB. |
| Download Datasheet |
|
|
|
|
| High Pass Filter for Interference Suppression from 9 kHz to 250 MHz | |
EMC / EMI Filter
from MTS Systemtechnik GmbH
|
| The MTA-HPF-150 from MTS Systemtechnik GmbH is a High Pass Filter (HPF) that operates from 9 kHz to 250 MHz. It has a passband insertion loss of less than 0.9 dB with a ripple of up to 0.5 dB. This filter utilizes 5-Pole Chebyshev filtering technology. This device can be connected between a line impedance stabilization network (LISN) and a test receiver to prevent disturbing signals below 150 kHz, enabling accurate and repeatable measurements. |
| Download Datasheet |
|
|
|
|
| Diode Pulse Limiter with 10 dB Attenuation from DC to 200 MHz | |
Transient Limiter
from Schwarzbeck Mess - Elektronik OHG
|
| The VTSD 9561 F from Schwarzbeck Mess - Elektronik OHG is a Diode Pulse Limiter that operates from DC to 200 MHz. It consists of a high-power attenuator along with an Osram 2306 fuse lamp that protects sensitive equipment when measuring spectra with high energy. The fuse lamp allows users to recognize overload conditions quickly and reliably, thereby preventing possible damage. |
| Download Datasheet |
|
|
Please wait...